Luxury Vinyl Plank (LVP)
A multi-layer, 100% waterproof plank that mimics wood. Florida's most popular floor for its durability and moisture resistance.
SPC (Stone Plastic Composite)
A rigid-core vinyl with a dense limestone-based core. Extremely stable and dent-resistant — ideal over Florida slabs.
WPC (Wood Plastic Composite)
A rigid-core vinyl with a foamed core — softer and warmer underfoot than SPC, but slightly less dent-resistant.
Rigid Core
The dense center layer (SPC or WPC) that lets a vinyl plank stay flat and stable over imperfect subfloors.
Wear Layer
The clear top layer protecting a vinyl plank from scratches, measured in mils. 12–20 mil is best for pets, rentals, and busy homes.
Mil
A thickness unit (one-thousandth of an inch) used to rate a vinyl plank's wear layer — higher mil means more durability.
AC Rating
An abrasion-resistance scale for laminate (AC1–AC5). AC4–AC5 are the durable, residential-to-commercial grades we install.
Engineered Hardwood
Real-wood veneer over a stable plywood core. Handles Florida humidity far better than solid wood — our recommended hardwood here.
Solid Hardwood
A single piece of wood throughout. Beautiful and refinishable many times, but more reactive to humidity than engineered.
Acclimation
Letting flooring sit in your home (often 48–72 hours) to adjust to its humidity before install — critical in Florida.
Vapor / Moisture Barrier
A membrane or coating that stops slab moisture from reaching the floor above. Essential over Gulf-Coast concrete.
Subfloor
The structural surface (slab or plywood) under your finished floor. Its flatness and dryness make or break an install.
Underlayment
A thin cushioning/moisture layer between subfloor and floor that adds comfort, quiet, and sometimes vapor protection.
Floating Floor
A floor that clicks together and 'floats' over the subfloor without glue or nails — common for LVP and laminate.
Glue-Down
Installing planks with full adhesive to the subfloor — more stable underfoot, often used for large LVP areas and stairs.
Lippage
A height difference between adjacent tiles or planks. Excess lippage signals a poor set or an unflat subfloor.
Thinset
The cement-based mortar that bonds tile to the subfloor. Full coverage and back-buttering prevent hollow, cracking tile.
Large-Format Tile
Tile with any side 15 inches or longer. Looks high-end but demands a dead-flat base and leveling clips to avoid lippage.
Refinishing
Sanding hardwood back to raw wood, then restaining and resealing — restoring a tired floor for a fraction of replacement cost.
Screen and Recoat
A light buff-and-coat that refreshes a hardwood floor's finish without a full sand-back. Faster and cheaper than refinishing.
Dustless Sanding
Refinishing with vacuum-attached sanders that capture most dust at the source — cleaner air and surfaces during the job.
Slab-on-Grade
A home built directly on a concrete slab (common in Florida). Demands moisture testing before any floor goes down.
Tongue-and-Groove
An interlocking plank edge profile that locks boards together for tight, even seams.
Transition Strip
A trim piece that bridges two floors (or a doorway) cleanly and hides the gap where materials meet.
Herringbone
A classic zig-zag plank pattern. High-impact but labor-intensive — priced above standard straight-lay installation.